Now serving all of Washington, Oregon, Northern California and Western Idaho!
All of our materials used are 100% galvanized
The base rail is the foundation of the building, each welded sleeve is approximately 4ft apart center to center.
Vary from sizes of 12 feet wide up to 60 feet wide.
They are 29 gauge in thickness. Our longest single panel is 31′ long.
34″ width and 72″ height
30″ width x 30″ height
All buildings anchored to ground come with pin anchors
unless building is being anchored down on concrete.
These are used for additional anchoring when needed.
These 18 gauge braces are used for center bracing and corner bracing. (2′, 3′, 4′ lengths depending on height of building)
Frame piece on A-frame Vertical roof that runs horizontal so sheet panels can be attached.
Used to reduce condensation on roof.
6×7, 8×7, 9×7, 10×8, 10×10
10×12, 12×12, 12×14, 14×14
Used to trim out windows and walk-in doors.
Used to trim out roll-up doors and edges of sheet
panels for horizontal roofs/sides.
Used for the peak of an A-frame Vertical where sheet panels meet.
Used to cover truss overhang on A-frame styles where roof and side panels meet.
The building looks great. And it only took about two hours. They arrived when they said they would, and all went well.
All Steel NW made the purchase of my RV cover easy!
Easy to deal with, friendly and knowledgeable about their product!